The Artpol M24x2.0mm die cuts right-hand metric threads on shafts made of carbon or low-alloy structural steel, cast steel, and non-ferrous metals. It is made of NC6 alloy tool steel (W-1.2063) and has clamping holes for die holders ø55x16mm.
- Type: Die
- Pieces: 1
- Thread type: Metric, coarse, right-hand
- Thread: M24
- Pitch: 2 mm
- Lead-in: 1.75P
- Profile angle: 60°
- Hardness: 60°HRc (±1°)
- Outside diameter: 55 mm
- Thickness: 16 mm
- Holes: 6
- Recommended shaft diameter: 23.82 mm
- Thread tolerance: ISO (6g)
- Standards: DIN-EN 22 568, ISO DIN-13
- Type
- Dies
- with Tap Wrench
- No
- Pieces
- 1 pcs
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.