The Artpol M10x1.25 mm die cuts right-hand metric threads on shafts made of carbon or low-alloy structural steel, cast steel, non-ferrous metals, and hardened plastics. It is made of NC6 alloy tool steel (W-1.2063), with a hardness of 60 °HRC (±1°).
- Type: Die
- Pieces: 1
- Thread: M10
- Thread pitch: 1.25 mm
- Outside diameter: 30 mm
- Thickness: 11 mm
- Number of slots: 4
- Recommended hole diameter: 9.85 mm
- Thread chamfer: 1.75P
- Thread angle: 60°
- Thread tolerance: ISO (6g)
- Standards: DIN-EN 22 568, ISO DIN-13
- Type
- Dies
- with Tap Wrench
- No
- Pieces
- 1 pcs
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.