The easiest and fastest method to inflate jumbo balloons.

Instructions for use:

• Secure the metal clamp of the balloon expander onto the work surface (bend the lower part of the clamp until it is fixed to the table).
• Connect the elastic tip to the air pump nozzle (electric pump, air compressor, or foot pump are recommended).
• Attach the jumbo balloon to the device's metal disc so that the blowing end of the balloon enters the disc's securing groove (jumbo balloons sized 45cm-120cm are recommended).
• Place the jumbo balloon and check it before starting to insert balloons to prevent air leaks. The device features a one-way valve that prevents air from escaping the jumbo balloon.
• The metal valve connected to the other end of the elastic tube consists of two parts that can be unscrewed. After disconnecting the thin valve used for inflating small balloons (inside the jumbo balloon), a larger valve remains for inflating the jumbo balloon.
• First, remove the thin valve and inflate the jumbo balloon to about one-third of its maximum size, then reconnect the thin valve.
• Insert the thin valve into a small balloon (5cm-25cm), then quickly insert both through the expander's valve so that the air from the jumbo balloon does not escape. Turn on the air pump until the balloon reaches the desired size, then hold the edge of the balloon with one hand to prevent slipping onto the jumbo balloon and remove the valve with the other hand. Tie the small balloon or knot it, then pass the knot through the valve. Thus, the first balloon is inflated inside the jumbo balloon!
• Inflate the small balloons one by one until the jumbo balloon is filled with small balloons or contains the desired number of balloons. As the jumbo balloon fills with small balloons, release some air from the jumbo balloon to prevent it from bursting. However, be careful not to release all the air from the jumbo balloon, as the small balloons may burst from the pressure of the jumbo balloon, and the remnants (burst balloons) cannot be removed from the large balloon.
• After inserting all the small balloons, disconnect the jumbo balloon from the expander disc.
• Inflate the jumbo balloon so that the balloons can move inside it. Tie the end of the jumbo balloon to prevent air loss.
• Hang the jumbo balloon from the ceiling or other high elements for a balloon piñata. Use a needle to burst the jumbo balloon.

Product type: Balloon device

Color: Blue

Product condition: New

Liquid type: None

Control type: Manual