12ml Drop Chamber, made of rubber, with a capacity of 60 drops and a precision flow regulator. It features a 150cm long tube and a Y connector, without needle, air chamber, and luer lock. The product has been sterilized with ethylene oxide and is available in blister packaging.

Intended use: Suitable for intravenous infusion, nutrition, and rapid administration in emergency treatment under gravity. Ensures precise flow rate control, with maximum performance and safety, for the prevention of cross-contamination.

Instructions for use:

• Select the appropriate infusion set model according to the patient’s condition.
• Open the intermediate packaging and remove it from the main packaging.
• Close the flow regulator clamp.
• Remove the protective cap and place the piercing device on the solution bottle’s stopper.
• Fill the drop chamber halfway by pressing and releasing.
• Remove the protector from the lower end.
• Partially open the clamp to the primary position.
• Perform venipuncture and connect the male luer to the venipuncture device.
• Adjust the flow using the flow regulator.
• Check the maintenance of the proper flow at regular intervals.

Storage: Keep in its original packaging in a dry and clean place, at a temperature below 40°C and relative humidity not exceeding 80%.

Warnings: Check the integrity of the packaging before use. Use immediately after opening. Device for use only by specialized medical personnel. Do not reuse. Treat used products as biohazardous materials.