Professional Replacement Liquid for Red Blue Vision 3rd Generation Headlamp Polisher. Restores and regenerates your car's headlights to their original condition and lasts for more than 3 years. The professional 800g liquid lasts for approximately 22 car headlights.

Application procedure:

• Mask the area around the headlights with masking tape.
• Sand the headlights with wet sandpaper and water, starting from P320 or P600, depending on the condition of the headlights.
• Continue with sandpaper P800, P1000, P1500, P2000 & P3000.
• Sanding should be thorough and even across the entire surface of the headlight.
• Place the liquid in the polisher above the middle of the container, to avoid the risk of burning the heating resistance.
• Close the heating container with one of the two lids and wait about 4-5 minutes for the liquid to boil.
• When you see steam starting to come out of the spout, bring the headlight to a distance of about 5cm, starting from bottom to top in a horizontal left-right motion, moving upwards slowly without leaving any gaps.
• The process is completed in less than a minute, and after 10 minutes the headlight is ready.

Attention: Always wear gloves, a mask, and protective goggles during use.