Category: Boat Balloons

Specifications:

• Lengths: 2 m / 3 m
• Material: HDPE + FRP (reinforced fiberglass)
• Adhesive tape: 3M-type self-adhesive tape
• Compatible with: fiberglass (gelcoat) and some aluminum boats with relatively straight cells

Installation Instructions:

1. Design: place the tape cold on the hull, mark the central axis and the start/end points.
2. Surface preparation: lightly sand the bonding area with fine Scotch-Brite or P180-P220 sandpaper until evenly matte and remove dust.
3. Degreasing process: wipe thoroughly with isopropyl alcohol and lint-free cloths, let it fully evaporate.
4. Painting: cover the edges and apply a very thin layer of 3M Tape Primer 94, wait about 5 minutes at room temperature until the film dries (for porous surfaces, apply 2 thin coats). Avoid excesses.
5. Working conditions: ideal tape + substrate temperature 20-30°C (avoid extreme temperatures). Avoid gaps of about 6 mm, areas with screws/sharp corners or high welds.

Main Benefits:

• Effective protection with HDPE + FRP composition, durability, and shock absorption capacity.
• Clean installation with 3M adhesive tape for secure fixation on properly prepared boats, neat appearance.
• Minimal maintenance, UV resistance, resistant to seawater and temperature changes, easy to clean.