The voltage detector combines the advantages of a traditional phase detector and a contactless voltage detector. It is suitable for detecting alternating voltage in sockets, wired routes, switches, and cables. Thanks to its pen-shaped design, it allows easy carrying in pockets.

The detector allows quick and easy checking of the live wire. It can detect alternating voltages from 70 - 250 V through contact. The LED light turns on when the cable is live. If the LED does not light up and an audible signal is heard, the voltage on the tested cable is less than 70 V AC. In non-contact mode, it can be used for voltages from 70 - 1000 V AC, minimizing the risk of electric shock.

Features:

• Safe non-contact detection
• Bright LED indication and audible signal when voltage is present
• Comfortable pen shape, suitable for pockets
• Polarity check
• Continuity test
• Sliding switch
• Belt clip

Functions:

• O = AC voltage test with contact (red LED)
• L = AC voltage test without contact (LOW) (green LED and audible signal)
• H = AC voltage test without contact (HIGH) (green LED and audible signal)

Warning!

• The detector must not be used for voltages exceeding the rated value.
• Optimal indication is guaranteed only at temperatures between -10 and +50°C and frequencies between 50-500 Hz.
• Signal visibility may be affected under adverse lighting conditions (e.g., direct sunlight).
• Before use, check the correct operation of the detector (AUTO-TEST).
• The detector must not be used in the presence of moisture (including dew, steam, or rain).
• The blade of the phase detector is intended only for voltage testing. Other work must be carried out with the power supply turned off! Do not use a damaged detector!

Available power:

• Operating temperature: -10°C to +50°C
• Voltage detection range (with contact): 70 V - 250 V (AC 50/60 Hz)
• Voltage detection range (without contact): 70 V - 1000 V (AC 50/60 Hz)
• Voltage detection range: >250 V DC
• Polarity check: 3 - 50 V DC
• Continuity test (depending on switch position):
  • 'O' = 0 - 5 MΩ
  • 'L' = 0 - 50 MΩ
  • 'H' = 0 - 100 MΩ

Protection: -

Power supply: 2 x 1.5V LR41 / 157 / V13GA / AG13 / A76 (included)

Dimensions: 145 x 20 x 17 mm

Weight (with batteries): ~15 g