The built-in nail dust collector MATRIX SYSTEM PRO - LUXORISE, silver, is designed to effectively collect dust particles generated during the abrasive process on gels, poly gels, or semi-permanent nail polishes. Designed for direct installation in the workspace, the MATRIX SYSTEM PRO - LUXORISE efficiently removes sanding residues, ensuring a clean and professional working environment.

Specifications:

• Model: LUX-X360MS PRO
• Power: 48W
• Speed: 3500 RPM
• Power supply: 220-240V 50Hz
• Dimensions: 260x260x80 mm
• Weight: 1500 g

The package includes:

• 1 x nail dust collector
• 1 x power supply
• 1 x controller
• 1 x jack-to-jack cable for connecting the controller
• 1 x user manual
• 1 x protective mesh
• 1 x filter
• Installation screws
• 1 x screwdriver

Instructions for use:

• Install the dust collector on the work table and connect it to the socket using the included power supply.
• Connect the controller with the cable and place the filter in its position.
• The control torque also functions as the ON/OFF button. Turn it clockwise to switch on the collector (you will hear a click). The device will start and the power indicator will light up green.
• Upon starting, the device is set to level 0. Turn the knob to increase the power.
• To decrease the power, turn the knob counterclockwise. If turned until it clicks, the device will automatically turn off.
• Short press the control button to pause the device. The power indicator will turn red. Press again to restart operation.

Cleaning instructions:

• It is recommended to clean the filter after 2-3 manicures.
• Use a soft brush to clean the surface of the filter or use an air blower (with cold air) to blow from the back side of the filter. Cleaning with water is not recommended as it may damage the filter.
• Replace the filter with a new one when suction power decreases (approximately every 3 months, depending on frequency of use).