The Milwaukee carbide drill bit with an SDS Max shank is designed for drilling structural materials. Its head has four cutting edges with 4 × 90° symmetry and a centring point with a 130° point angle for precise starting and guidance. The bevels on the carbide tip help prevent jamming when the bit encounters rebar.
The large secondary cutting edge supports the primary edge for faster drilling, while the smaller spiral and deep flute shoulders help remove dust and reduce wear and heat. The reinforced flute geometry reduces vibration and breakage, while the sandblasted surface improves wear resistance. It complies with PGM standards for precision in anchor installation holes.
- Pieces: 1
- Material: Carbide
- Drilling material: Structural materials
- Shank: SDS Max
- Diameter: 20 mm
- Overall length: 520 mm
- Working length: 400 mm
- Point angle: 130°
- Cutting-edge geometry: 4 × 90°
- Compliance: PGM
- Pilot drilling: With a short drill bit of the same diameter
- Drill Material
- Carbide
- Suitable for
- Masonry
- Drill Top
- SDS Max
- Set with Tips
- No
- Pieces
- 1 pcs
- Length
- 520 mm
- Diameter
- 20 mm, 32 mm
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.