The reinforced roll-up CONTREJOUR sunshade is a high-quality system designed to provide heat protection and offer optimal comfort in your vehicle. Thanks to its adjustable structure with sliding rails and suction cups, it adapts to the width of the windshield and ensures optimal sun protection.

Its sturdy design ensures long-lasting use, protecting the vehicle’s equipment (dashboard, upholstery, instruments) from UV rays and premature wear.

Instructions for use: Place the two plastic hooks on the vehicle’s existing sun visors, on the driver’s side and the passenger’s side. Screw the two suction cups onto each screw thread located at the ends of the slider. Open the slider along the inner base of the windshield to adjust it to the width of the windshield. Attach the suction cups to the right and left ends of the lower inner edge of the windshield.

Tip: Lightly wet the back of the suction cups to improve adhesion. Unroll each of the two fabric rollers until it fully covers the windshield, then hold it open by placing the handle on the hooks installed on the vehicle’s interior sun visors.

Make sure the sunshade is taut and covers the entire windshield. When leaving, roll up both fabric rollers, detach the suction cups, and close the slider.

Store the product in its storage case.

Maximum length 143 cm

Maximum height 104 cm

This product must be used only when stationary!