Description
Specifications
The Flipper Zero is a standalone, multifunctional microelectronics tool with an LCD and a 5-way navigation pad. It supports reading, writing, emulating, and analyzing RF, RFID, and IR signals, as well as HID emulation via USB. It can connect to a computer or an Android or iOS app for expansion, modification, and updates.
Its features also include GPIO, 1-Wire, Bluetooth, a USB bridge to SPI, UART, and I2C, as well as use as a U2F security key for supported services.
- Display: 1.4″ monochrome LCD, 128 × 64 px, with backlight
- Navigation pad: 5-way
- Battery: 2000 mAh Li-Pol, with up to 7 days of battery life on a single charge
- Processor: STM32WB55RG, ARM Cortex-M4 32-bit 64 MHz and ARM Cortex-M0+ 32 MHz
- Memory: 1024 kB Flash and 256 kB SRAM
- Storage: microSD up to 64 GB
- Connectivity: USB 2.0 Type-C and Bluetooth
- RF: TI CC1101, 315 MHz, 433 MHz, 868 MHz, and 915 MHz, maximum TX power 0 dBm, range up to approximately 100 m
- RFID: 13.56 MHz ISO-14443A/B, NXP Mifare® Classic/Ultralight/DESFire/etc, FeliCa, and Forum NFC
- 125 kHz RFID: AM/PSK/FSK modulation, EM400x, EM410x, EM420x, HIDProx, Indala, and T5577
- GPIO: 3.3 V CMOS level, 5 V tolerant, and up to 20 mA per digital pin
- Infrared: RX/TX 800 nm to 950 nm, transmission power 0 dBm, maximum RX sensitivity -96 dBm, and speed 2 Mb/s
- iButton 1-Wire: Dallas DS1990A and CYFRAL
- Buzzer: 100 Hz to 2500 Hz
- Additional features: microSD slot and vibration motor
- Charging and flashing: Via USB Type-C
- Dimensions: 100 × 40 × 25 mm
- Weight: 102 g
- Type
- -
- Packaging
- -
- Operating Voltage
- -
- Ecosystem
- -
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.