Kraft Bodenguard AR-120 epoxy primer is a two-component product intended for metal and other non-absorbent surfaces, for indoor and outdoor use. It provides adhesion and anticorrosive protection for iron and steel surfaces and is applied before Bodenguard range epoxy and polyurethane products. Its composition consists of epoxy resin in Component A and a polyamide blend in Component B.
Apply to a clean, stable and sound substrate after sanding, brushing or sandblasting and removing dust. Apply one coat when using as an adhesion primer, or two coats for increased anticorrosive protection. It may optionally be thinned with Kraft NITRO 2000 and applied by roller, brush or airless spray gun. For professional use only.
- Type: Two-component epoxy primer
- Application surfaces: Metal and non-absorbent surfaces
- Use: Interior and exterior
- Properties: Adhesion-promoting and anticorrosive
- Component A composition: Epoxy resin
- Component B composition: Polyamide blend
- Mixing ratio A:B: 100:20 by weight
- Thinning: Optional, 5–15% by weight with Kraft NITRO 2000
- Application: By roller, brush or airless spray gun
- Coats: 1 for adhesion or 2 for increased anticorrosive protection
- Coverage: 0.150–0.200 kg/m² per coat
- Density: 1.43 g/mL (±0.05) at 25°C
- Weight solids: 77.0% (±2)
- Volume solids: 62.3% (±2)
- Viscosity: 2020 mPa.s (±100) at 25°C
- Pot life: 2.5–3.5 hours at 15°C, 2.0–2.5 hours at 25°C and 1.5–2.0 hours at 35°C
- Drying time: Approximately 3 hours
- Walkability: 16 hours
- Recoating: 16–24 hours
- Curing time: 7 days
- Dry film thickness: Over 70 μm on non-absorbent surfaces and over 140 μm on iron surfaces
- Adhesion: ≥ 4.0 N/mm²
- Pendulum hardness: 115 sec (±15) after 15 days
- Conical mandrel bend resistance: ø < 3.5 mm
- Glass transition temperature: 110.1°C
- Reaction to fire: E
- Maximum VOC content of ready-to-use product: 499 g/L
- Marking: CE according to EN 1504-7 and EN 13813
- Colour: Grey
- Set weight: 1.2 kg (Component A 1 kg and Component B 0.2 kg) or 6 kg (Component A 5 kg and Component B 1 kg)
- Application temperature: 15–25°C, with a substrate temperature of at least 5°C
- Substrate preparation: Clean, stable and sound, free of standing water, rust, dust, oils, tar or loose material, with moisture content below 4%
- Mixture preparation: Add all of Component B to Component A and mix for 1–2 minutes
- Application precautions: Do not apply in damp conditions; ensure adequate ventilation and use personal protective equipment in enclosed areas
- Product Number
- JK38297200002
Specifications
- Genre
- Primer
- Surface Material
- Metal
- Surfaces
- Multiprimer
- Properties
- Antirust, Adhesion, Solvent-Base, Polyurethane, Water
Quantity
- Weight
- 1 kg
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.