Primers

Kraft Primer Suitable for Metal 5kg Code: JK38297100015

Kraft Bodenguard AR-120 primer is a two-component, solvent-based epoxy adhesion primer with anti-corrosion protection for iron and steel surfaces. It can be applied to horizontal or vertical metal...

Kraft Bodenguard AR-120 primer is a two-component, solvent-based epoxy adhesion primer with anti-corrosion protection for iron and steel surfaces. It can be applied to horizontal or vertical metal structures and other non-absorbent surfaces, indoors and outdoors, before applying Bodenguard range epoxy and polyurethane products. One coat is used as an...

See Description & Specifications See Description & Specifications
The product is not available for shipping to the selected country.

Description & Specifications

Kraft Bodenguard AR-120 primer is a two-component, solvent-based epoxy adhesion primer with anti-corrosion protection for iron and steel surfaces. It can be applied to horizontal or vertical metal structures and other non-absorbent surfaces, indoors and outdoors, before applying Bodenguard range epoxy and polyurethane products. One coat is used as an adhesion primer, while two coats provide high anti-corrosion protection.

The formulation contains epoxy resin in component A and a polyamide blend in component B. The substrate must be clean and sound, with a moisture content below 4%. Mix the two components for 1–2 minutes, by hand or with a low-speed drill, and apply the product with a roller, brush or airless spray gun. Thinning is optional with Kraft NITRO 2000. Recoating should be carried out within 24 hours.

  • Type: Adhesion primer
  • Surface material: Metal
  • Surfaces: Interior and exterior
  • Properties: Anti-rust, anti-corrosion, adhesion-promoting, solvent-based, two-component epoxy
  • Composition: Epoxy resin and polyamide blend
  • Mixing ratio by weight: 100:20 (A:B)
  • Thinning: Optional, 5–15% by weight with Kraft NITRO 2000
  • Coverage: 0.150–0.200 kg/m² per coat
  • Pot life: 2.5–3.5 hours at 15°C, 2.0–2.5 hours at 25°C and 1.5–2.0 hours at 35°C
  • Drying time: Approximately 3 hours
  • Walk-on time: 16 hours
  • Recoating: 16–24 hours
  • Curing time: 7 days
  • Density: 1.43 g/mL (±0.05) at 25°C
  • Solids by weight: 77.0% (±2)
  • Solids by volume: 62.3% (±2)
  • Viscosity: 2020 mPa·s (±100) at 25°C
  • Dry film thickness: >70 μm on non-absorbent surfaces and >140 μm on iron surfaces
  • Pendulum hardness: 115 sec (±15) after 15 days
  • Flexibility: ø <3.5 mm
  • Adhesion: ≥4.0 N/mm²
  • Glass transition temperature: 110.1°C
  • Reaction to fire: E
  • VOC content: 499 g/L maximum
  • Standards: CE marked according to EN 1504-7 and EN 13813
  • Weight: 5 kg

Manufacturer

Product Number
JK38297100015

Specifications

Genre
Primer
Surface Material
Metal
Surfaces
Multiprimer
Properties
Antirust, Adhesion, Solvent-Base, Polyurethane, Water

Quantity

Weight
5 kg

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.