Happy New Year and good health to everyone.
I bought it 4 years ago and I got it with reservations because everyone said it would break down, etc. On the contrary, after continuous use in our fields, it has never let me down, it cuts whatever is needed within reasonable limits, I haven't changed any spare parts except for the fuel hose which got punctured. Light, easy to use and can be operated with one hand for small trunks. In general, I will choose Hyundai again for the next one, I didn't expect it to turn out so good.

Worked fine until it stopped- from one day to the next. Used about 5 times in one year.
Have returned it to Skroutz. Apparently a carburetor problem. Will see what the company says.

I bought it 7 years ago and I cut almost 2 tons of olives, and trunks with a diameter of 40 cm EASILY. After two years, the hoses dried out and every year I had to replace them because they would get punctured. In the third year, the electronics broke down, then the carburetor, and then I decided not to bother with it anymore because it started demanding more than it was cutting. It's worth it if someone wants to get it and use it hard for a couple of years, after that you'll have it in the service shop more than in the storage. It does earn its money decently though, and it cut trunks WELL ABOVE its capabilities.

I bought the tool with great reservations about its reliability. But when I put it on the trunk of an oak, dry hard wood, 60 centimeters in diameter and a bit larger with knots, the machine did not hesitate for its price... You need to be careful with how you cut the wood; if you plunge it in, obviously it will get stuck. It's 5 horsepower. I was cutting tree trunks for 2 hours; the only thing it needed was a lot of gasoline, to be honest, but otherwise I am very satisfied. Now, how long it will last is another matter.

The machine is awesome!! It doesn't have any trouble and we've cut very thick trees!! The instructions are useless but if you go on YouTube there's a detailed video!!

I had bought it with the carving bar, it worked for me for five years without any problems, then the problems started so I decided to get another one. I bought the new one, used it once and then left it aside for two months. When I went to use it again, I put in gasoline and it started leaking everywhere. I took it to the service, OF COURSE THE WARRANTY DID NOT APPLY, the hoses are fake, they told me...

It is powerful but the oil sent by the pump for chain lubrication is not enough, resulting in the chain sticking. After 2 hours of work, the clutch broke and that was the end..

I have 2. One for work at the construction site and the other for firewood. The first one didn't work smoothly and I saw a review in the ratings that explained how to adjust it and now it works fine.

I read many comments... in the end, I got it... I am impressed that a machine costing 100 euros is rated alongside a machine costing 400 euros... so this machine is the best for its price... lightweight... can be operated with one hand... perfect for pruning olive trees... and it cuts large branches easily...

The weight is not what is stated, i.e. 2.9kg. The weight - without blade, chain, and fuel - is 3.256kg. I had the same one for about three years, and now I bought the same one again to have the old one as a spare. The old one worked relatively well, but it was losing a lot of oil. It became inoperative because it had a major fuel leakage due to the fuel tank breaking, and the repair was not cost-effective.

Well guys, I've had it for four years, maybe even more, I've drunk its blood, olive branches, tree trunks for firewood, the machine never betrayed me. I also found out that it loses oil from the cap. Okay, you place it sideways and the problem is solved. Good cleaning after use, no gasoline in the carburetor after the end of work & correct ratio of gasoline to oil. Get it with your eyes closed. We're talking about a beast.

Good tool, lightweight and so far it has proven to be durable!! It is a very good value for the money!!

I bought it used from a friend for 50€. I was very impressed by its quality. As a mechanical engineer and having used many saws in my hands, mainly branded ones, I can say that it is very good value for the money. And one more thing, the country of manufacture is listed as Korea, not China.

Very good value for money..BUT..once it is set up, it definitely needs ADJUSTMENT!!! I turned both screws all the way in, loosened the H 2 turns and the L 1.5 turns

I bought it from a local store in Serres, everything is fine for a start, it starts easily. I also have the Stihl MS 170, I bought this one for the olives because I work with one hand. The only thing I noticed is that it leaks oil when it is in operation. Also, it doesn't oil the chain properly, sometimes it runs too much, other times not at all. I took it back to where I bought it, they have a setting for the oil flow on the chain, exactly below. If you close the pump, it won't leak oil, but that's not a solution, it shouldn't leak for any reason. But okay, for 100 euros, it's good

I have it for almost 3 years. It leaks oil and wherever you leave it, it will stain you. It constantly loses its idle and adjusts the RPMs, while for some reason, when I work with it with the throttle open, something happens with the fuel supply and it stalls and shuts off. After shutting off, it struggles to start and doesn't take. In my opinion... it's not even worth its money, get another Chinese one

New chainsaw, the oil pump in the chain does not run and during storage it leaks oil

I have had it for two weeks and the only thing I can say is that it cuts very well. The only drawback is that it doesn't respond immediately when I press the gas, and from what I understand, it must be the carburetor that needs adjustment!!!!!!!!!!!!!!!!!!!!!!!

After 5 years of use everywhere, and when I say everywhere... (pruning, shredding, clearing, and anywhere there is a wooden pole)... I mean... EVERYWHERE! After this intensive use, it needed a new bar, oil pump, and fuel lines at minimal cost. The initial purchase price paid off many times over, I would recommend it without hesitation!
March 2026... It cut around 50 tons of wood!!! Its plastics are collapsing, the leaks (oil, fuel) are now irreversible (economically unfeasible to repair). So the warrior will give its place to the NEW one coming to continue the work of its predecessor!

I have been using it for about 3 years for amateur use, pruning branches of garden trees and olive trees. It works very well, it has not presented any problems to me, of course I am meticulous in its cleanliness and maintenance, it starts easily like any two-stroke machine can.

Well, this machine is good value for money. It will last you two years if you cut 4-5 tons per year. It cuts thick branches just like I did. I'm not saying it's not worth the money, on the contrary, the Chinese have improved a lot. The problem is that Huandai has nothing to do with this product. If you search the internet, you won't find any Huandai chainsaws anywhere in the world. So there's no reason to pay 40 euros or more when you can get the Nagea for 60, which is slightly better. That's the whole truth

I pruned an olive tree and it caught fire. I sent it to the dealership and they told me they will respond on October 20, 2020! I have called so many times, I don't know how many, but they always tell me that it is in service and I still haven't received the machine a year later. Shame and disgrace from Hyundai.... From now on, only Echo and Stihl.

I bought it in September 2020. From the first moment, it was losing oil, so I took it for service. I did a test using a fuel tank and it remained intact throughout the winter. Now, at the end of July 2021, I decided to use it for pruning. I fill it with fuel, try to pump gasoline, nothing... it doesn't work. I open it up, fuel hoses are cut... what can I say... the most useless purchase I have ever made... a waste of 100 euros.

Friendly advice, get a more reputable pruning tool or, for occasional use like mine, it's probably better to go with a battery-powered one.

Update 27/8
After repairing it at the mechanic who replaced the hoses, the machine is now working for pruning.
Let's see how long it will last...
Changing my rating to 3/5.

Update 14/12/23
It's actually very good, changing my rating to 4 stars

I bought this chainsaw two years ago. In the first year, the handle's wheel broke, but luckily there was a spare part in the packaging and I replaced it. Now I found its button and it fits easily. It pulls twice with the choke closed and starts with two pulls with the choke open. It can even cut larger tree trunks, but it doesn't require much force. It has a good advantage of having oil flow adjustment for the blade/chain. At the end of the season, I empty the carburetor completely into the gasoline (without oil) for an hour and then I store it without starting it. After 5 months of inactivity, it is like new.

The worst thing on the market. On the third day, the carburetor broke, we put a new one and after a week it started moving forward for the 20th time. But after it retards again, I threw it in a corner in the warehouse and I calmed down. There is no cheap and good, if you want my opinion, buy a branded one so you don't have any problems.

Very good for its price. The branded ones are very expensive. If in some cases, by pressing the gas, it turns off or sounds like it's clogged, and even though they adjust it after a few hours, it's still the same. The culprit is the vent valve of the tank, which is below the gas system switch. If your hands get dirty, you can easily change it with one euro.

For 135 euros, it is more than good, almost perfect (if it didn't lose oil from the chain during storage, where you have to keep it with the frame so it doesn't empty!)

Well, it is 100% Chinese but of very good quality... It has nothing to do with Hyundai, the Greek representative here just used the name and, of course, paid the rights to Hyundai.... You can find the same tool for 50 euros with a different name, not for 95.

The plastic is bad, heavy for many cuts, starts with the 4th. It cuts relatively well but I wouldn't recommend it when there are so many others on the market with better features and more reliable.