So today, 11/03, I bought this stand and I want to say a few words that if everyone did, it would make purchasing certain products easier. After contacting the online store, they kindly informed me that it was in stock, and of course, they provided the technical specifications such as inches, weight, and the main thing, the Vesa (the distance from the back of the TV from screw to screw horizontally and vertically). I went there to pick it up and the girls at the pickup were also very polite. They allowed me to open it and I noticed the screws. I commented that they probably wouldn't fit because I had seen the back of my TV (Samsung 55" UHD Ultra 4K) that I had just bought and intentionally opened to see how the cables fit, which is very important because this stand doesn't leave any room. On this TV, the power outlets are downward and the VESA doesn't obstruct the HDMI and USB on the sides, which was convenient for this stand. So, the screws seemed short to me because my TV had deep holes in the back and I also had extra spacers in the package to align the slightly curved back. I told them this, but they said no, the screws are standard. I insisted because it bothered my eye, and I told them I would check it myself, although I don't think I will need extra screws. I had the TV manual with me, so being a bit of a perfectionist, I went to a hardware store nearby, showed them the numbers from the manual, and they gave me the appropriate screws, 43-45cm, M8 type, 4 pieces. And after I returned home, it was confirmed. I'm talking about the screws that go on the top and back of the TV, the two parts of the stand that then go together on the wall. So, luckily, I bought the screws! The stand is perfect, very sturdy, it had 4 strong screws inside with 4 washers, but I used a total of 8 screws on the wall, 4 extra ones. And even Tarzan couldn't make it fall! Very satisfying and of course, value for money. I hope I helped everyone!