• With an inhalation indicator for medication administration control.
• Combines mask and mouthpiece together.
• Made from antistatic PETG material.
• BPA FREE (non-toxic plastic). Safe non-toxic plastic without bisphenol A.
• Small handy size.

1. Before each use, a visual inspection of the inside of the spacer device must be performed. If any defect is found, the device should be replaced.

2. Remove the cap from the inhaler, shake well, and insert it into the spacer device.

3. Place the mask on the face and ensure there will be no leaks during inhalation.

4. Press the inhaler while ensuring the patient inhales slowly. If the whistle sound is heard, then the inhalation should be done at a slower pace. During inhalation, the inhalation indicator moves towards the patient as they inhale normally.

5. The mask should remain applied to the patient's face for 5-6 breaths with the administration of one spray.

• Remove the rear part of the spacer device.
• Immerse all parts of the spacer device in lukewarm water and mild cleaning solution.
• Avoid scrubbing the parts of the spacer device with a cloth or sponge.
• Rinse the parts of the spacer device with clean water. Alternatively, remove all parts of the spacer device and place them on the top rack of the dishwasher in an upright position.
• Place the parts of the spacer device in a vertical position on a dry surface to dry. 
• Avoid drying the parts of the spacer device with a cloth or paper towel.
• Before reassembling the spacer device, ensure that all its parts are dry.
• The spacer device should be replaced after one year of use.