• Check if the controller's connection cable is connected to the plug on the heating pad.
• Plug the plug into the socket and move the sliding switch from position 0 to position 1. The LED operation indicator initially lights up in orange (preheating stage) and after heating, it lights up in green. 
• After a few minutes, you will feel the heating of the pad. If you want a higher temperature, move the switch further to the next position 2 or 3 or to the maximum temperature at position 4. If you feel that the electric pad has become too hot, return the switch to position 3, 2, or 1. After a short period, the electric pad cools down noticeably. 
• The heating pad has electronic regulation with particular accuracy. Depending on the room temperature and the setting, the LED light can switch from orange to green and vice versa within a few seconds. This indicates the start of supplementary heating to meet the required needs and is completely normal. To turn off the device, return the switch to position 0. 
• The extinguishing of the red operation indicator light indicates that the device has been turned off. Then disconnect the plug from the socket. Before sleeping or if you want to use the device continuously, set the switch to position 1. After approx. 90 minutes of continuous operation, the pad automatically turns off. 
• To turn it on again, move the switch to position zero and then back to the desired heating level. 
• Disconnect the plug from the socket when you do not intend to use the electric pad anymore.

The special shape facilitates use especially in the shoulder, neck, and back areas. The use helps in blood circulation in tight muscle areas and well-being after a tiring day.

The pad is equipped with an electric temperature control system, which controls the set temperature according to the selected switch level.

Through the two locking press buttons in the front area and the practical belt, the HP 630 heating pad remains in place.

• Before cleaning the pad, disconnect the plug from the socket and let it cool for at least ten minutes.
• The heating pad is equipped with a removable controller (HP 630). Remove the controller from the heating pad by disconnecting the connecting cable from the plug on the heating pad. 
• Clean the heating pad with dry cleaning (with a soft brush) or according to the printed care instructions. 
• Never use strong detergents or hard brushes. 
• After washing, let the heating pad dry spread out on a flat surface. Use the heating pad again only when it is completely dry. 
• Connect the controller cable to the heating pad (one arrow points to the other).

At regular intervals, you should unwind the cable if it has become tangled.

Store the pad open and flat without placing anything on top of it in a clean and dry place.