Skroutz.mt

Lewitt LCT 640TS Condenser Microphone XLR Shock Mounted for Vocals
Microphones

Lewitt LCT 640TS Condenser Microphone XLR Shock Mounted for Vocals

Acoustic operating principle: Condenser, Pressure transducer, externally polarized condenser D25.4 mm - 1 inch

  • Omnidirectional pattern
  • Wide cardioid
  • Cardioid
  • Super-cardioid
  • Figure-8

Remote control...

Acoustic operating principle: Condenser, Pressure transducer, externally polarized condenser D25.4 mm - 1 inch

  • Omnidirectional pattern
  • Wide cardioid
  • Cardioid
  • Super-cardioid
  • Figure-8

Remote control capability

Frequency range 20 ... 20,000 Hz

Sensitivity 23 mV / Pa (-33 dBV), cardioid 20 mV / Pa (-34 dBV), omni 23 mV / Pa (-33 dBV), figure-8

Signal-to-noise...

See full description See full description
  • Type (Directivity) Multipattern
  • Usage Vocal, Musical Instruments, Studio
  • Placement Shock Mounted
  • Connectivity XLR
  • See all
845 00 €
Delivery by Mon, 29 Jun
14,00 €   shipping cost
Sent from Greece
From Stollas 4.9 (33)
4.9 (33 reviews)
Greece
1 piece
See Audio on the page of Stollas
Review the product
Product report

Description

Description

Acoustic operating principle: Condenser, Pressure transducer, externally polarized condenser D25.4 mm - 1 inch

  • Omnidirectional pattern
  • Wide cardioid
  • Cardioid
  • Super-cardioid
  • Figure-8

Remote control capability

Frequency range 20 ... 20,000 Hz

Sensitivity 23 mV / Pa (-33 dBV), cardioid 20 mV / Pa (-34 dBV), omni 23 mV / Pa (-33 dBV), figure-8

Signal-to-noise ratio 85 dB-A

Equivalent noise level (IEC 61672-1) 9 dB-A, cardioid - 10 dB-A, omni (IEC 61672-1) - 9 dB-A, figure-8 (IEC 61672-1)

Dynamic range mic. Ampl. 130 dB-A

Max. SPL for 0.5 % THD 139 dB, 0 dB Pre-attenuation - 149 dB, 10 dB Pre-attenuation - 159 dB, 20 dB Pre-attenuation - Pre-attenuation pad 10 dB 20 dB with remote control capability

Bass cut filter rate 12 dB / octave at 40 Hz - 6 dB / octave at 300 Hz

Nominal impedance 1,000 ohms

Adapted power supply unit 230 V, 50 Hz - 110 V, 60 Hz

Instantaneous consumption 1

Manufacturer

Manufacturer Details

Warnings & Safety Information
See full description

Specifications

Specifications

Dimensions

Mode of Operation
Πυκνωτικό (Μεγάλου Διαφράγματος)

Mode of Operation

Πυκνωτικό (Μεγάλου Διαφράγματος)
Warm and full sound with emphasis on vocals. Mainly used in studios for vocals and solo instruments.
Directivity
Multipattern
Frequency
20 - 20000 Hz

Frequency

Indicates the frequency range that a microphone can capture and is expressed in Hertz (Hz). The more balanced the range, the more natural and clear the sound.

Usage examples:

  • 100 – 10,000 Hz to 200 – 12,000 Hz: Emphasis on speech intelligibility, with limited low and very high frequencies.
  • 50 – 14,000 Hz to 80 – 16,000 Hz: Balance of volume and clarity. Ideal for live performances and dynamic microphones.
  • 40 – 15,000 Hz to 50 – 18,000 Hz: Rich, natural vocal sound. Suitable for podcasts, radio, and streaming.
  • 20 – 18,000 Hz to 20 – 20,000 Hz: Full spectrum with high detail and "air". Ideal for studio recording.
  • Below 20 Hz & above 20,000 Hz: Extended technical range for specialized studio applications.
Impendance
150 ohm

Impendance

Indicates how "easily" the microphone transmits its signal to the equipment (mixer, sound card, amplifier). It is expressed in Ohms (Ω).

  • Low impedance (≤ 600 Ω): Stable signal, less noise, ideal for professional equipment and long cable runs.
  • Medium impedance (600 – 1,000 Ω): Good balance, common in live and general use.
  • High impedance (> 1,000 Ω): More sensitive to loss and noise, usually found in older or specialized equipment.
Sensitivity
13 mV/Pa

Sensitivity

The sensitivity of a microphone indicates how strong the signal it produces is when recording a sound. It is measured in mV/Pa or dBV/Pa.

  • High sensitivity: The microphone can capture very low sounds, but it may be more sensitive to ambient noise.
  • Low sensitivity: It records louder sound sources without distortion, but requires more amplification from the preamp.

In general, condenser microphones have higher sensitivity than dynamic ones.

Max SPL
139 dB

Max SPL

Max SPL (Maximum Sound Pressure Level) is the maximum sound pressure level (in dB) that a microphone can withstand before it starts to distort the sound.

  • High Max SPL (e.g., 140-160dB): Ideal for recording loud sources such as drums, amplified guitar, or live concerts.
  • Lower Max SPL (e.g., 120dB): Suitable for vocals and softer recordings.

The higher the Max SPL, the louder the sounds it can capture without distortion.
Connectivity
XLR

General Characteristics

Device Group
Vocal, Musical Instruments, Studio
Placement
Shock Mounted
Vintage
No
Set
No
Color
Black

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.

See all specifications

Description & Specifications

Acoustic operating principle: Condenser, Pressure transducer, externally polarized condenser D25.4 mm - 1 inch

  • Omnidirectional pattern
  • Wide cardioid
  • Cardioid
  • Super-cardioid
  • Figure-8

Remote control capability

Frequency range 20 ... 20,000 Hz

Sensitivity 23 mV / Pa (-33 dBV), cardioid 20 mV / Pa (-34 dBV), omni 23 mV / Pa (-33 dBV), figure-8

Signal-to-noise ratio 85 dB-A

Equivalent noise level (IEC 61672-1) 9 dB-A, cardioid - 10 dB-A, omni (IEC 61672-1) - 9 dB-A, figure-8 (IEC 61672-1)

Dynamic range mic. Ampl. 130 dB-A

Max. SPL for 0.5 % THD 139 dB, 0 dB Pre-attenuation - 149 dB, 10 dB Pre-attenuation - 159 dB, 20 dB Pre-attenuation - Pre-attenuation pad 10 dB 20 dB with remote control capability

Bass cut filter rate 12 dB / octave at 40 Hz - 6 dB / octave at 300 Hz

Nominal impedance 1,000 ohms

Adapted power supply unit 230 V, 50 Hz - 110 V, 60 Hz

Instantaneous consumption 1

Manufacturer

Manufacturer Details

Warnings & Safety Information

Dimensions

Mode of Operation
Πυκνωτικό (Μεγάλου Διαφράγματος)

Mode of Operation

Πυκνωτικό (Μεγάλου Διαφράγματος)
Warm and full sound with emphasis on vocals. Mainly used in studios for vocals and solo instruments.
Directivity
Multipattern
Frequency
20 - 20000 Hz

Frequency

Indicates the frequency range that a microphone can capture and is expressed in Hertz (Hz). The more balanced the range, the more natural and clear the sound.

Usage examples:

  • 100 – 10,000 Hz to 200 – 12,000 Hz: Emphasis on speech intelligibility, with limited low and very high frequencies.
  • 50 – 14,000 Hz to 80 – 16,000 Hz: Balance of volume and clarity. Ideal for live performances and dynamic microphones.
  • 40 – 15,000 Hz to 50 – 18,000 Hz: Rich, natural vocal sound. Suitable for podcasts, radio, and streaming.
  • 20 – 18,000 Hz to 20 – 20,000 Hz: Full spectrum with high detail and "air". Ideal for studio recording.
  • Below 20 Hz & above 20,000 Hz: Extended technical range for specialized studio applications.
Impendance
150 ohm

Impendance

Indicates how "easily" the microphone transmits its signal to the equipment (mixer, sound card, amplifier). It is expressed in Ohms (Ω).

  • Low impedance (≤ 600 Ω): Stable signal, less noise, ideal for professional equipment and long cable runs.
  • Medium impedance (600 – 1,000 Ω): Good balance, common in live and general use.
  • High impedance (> 1,000 Ω): More sensitive to loss and noise, usually found in older or specialized equipment.
Sensitivity
13 mV/Pa

Sensitivity

The sensitivity of a microphone indicates how strong the signal it produces is when recording a sound. It is measured in mV/Pa or dBV/Pa.

  • High sensitivity: The microphone can capture very low sounds, but it may be more sensitive to ambient noise.
  • Low sensitivity: It records louder sound sources without distortion, but requires more amplification from the preamp.

In general, condenser microphones have higher sensitivity than dynamic ones.

Max SPL
139 dB

Max SPL

Max SPL (Maximum Sound Pressure Level) is the maximum sound pressure level (in dB) that a microphone can withstand before it starts to distort the sound.

  • High Max SPL (e.g., 140-160dB): Ideal for recording loud sources such as drums, amplified guitar, or live concerts.
  • Lower Max SPL (e.g., 120dB): Suitable for vocals and softer recordings.

The higher the Max SPL, the louder the sounds it can capture without distortion.
Connectivity
XLR

General Characteristics

Device Group
Vocal, Musical Instruments, Studio
Placement
Shock Mounted
Vintage
No
Set
No
Color
Black

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.

845,00 €
14,00 €   shipping cost