The European-type AKAN radiators excel in performance because the heat conduction to the environment is done by air, which smoothly diffuses into the daily circulation environment of people and thus disperses at a low speed. In contrast, for example, in panel-type radiators, the heated air is transferred at high speed through the meanders and directed towards the ceiling of the space where it remains until it cools, dispersing a small percentage of its heating performance into the human environment.

Additionally, due to the large amount of water, they have high heat capacity and, therefore, create a consistently pleasant heating environment that is not affected by fluctuations in the central supply and continues to provide warmth even after the central heating supply is turned off. The large amount of water contained in the radiators allows for a small change in the outlet water temperature from the inlet temperature, resulting in significantly improved performance. These are also the reasons why we ensure great energy savings.

The radiators from Metallurgy Attikis, ensure ideal heating conditions, because they provide 60% of the heat through conduction and 40% of the heat through radiation. This exact ratio gives a pleasant feeling to people. They have the highest calorie output for the same volume compared to other types of radiators.

They are four-hole (4 threaded holes ½¨). Each radiator comes with the corresponding support set. The support set can be placed on the radiator in any position that serves the needs and peculiarities of the space. They come with 1 sealing cap ½¨ and 1 air vent valve ½¨ brass chrome-plated.

They are manufactured with the most modern machinery to ensure complete sealing and the longest operation.

It features 12 sections and each section consists of 4 water columns.

The height between the holes is 65.5 cm while the total height is 74.5 cm.

It is very important to make the right choice of radiator according to the dimensions of your space. The sizing of radiators should be done by an engineer after studying the space and calculating losses. Incorrect selection of the radiator can lead to insufficient heating or excessive heating of the space, resulting in energy waste.

A practical and simple way to calculate the required calories yourself is to multiply the height, width, and length of your room in meters. Then, multiply the result by the number 50, which approximately represents potential losses.

However, be careful, this calculation method is indicative and does not replace the study that an engineer will conduct, which will be absolutely accurate.